Automatic machines coating powder coating gun for metals1

Reason:
1. The furnace temperature is too high or too low

2. Curing time is too long or too short

3. Insufficient exhaust of curing furnace

Solution
1. Adjust the furnace temperature of the curing furnace
2. Adjust the chain speed
3. Check the exhaust system or increase the exhaust air hole

1. The powder coating booth is made of anti-static imported engineering plastic ,the structure is like  a sandwich ,so that it can  ensure a higher powder yield, the smallest powder retentate, the fastest speed of cleaning.

2. The rate of the cyclone special separation technology is up to 98% once  ,so that it can  save powder. Solve the problem of powder on the dead angle of the workpiece thoroughly.

3. The bottom of the powder coating booth is equipped with automatic turning-over device or automatic cleaning air knife, the bottom floor of the spray room is almost no powder retentate.

 4. The powder supply center  achieves the automatic circulation of the powder thoroughly. The powder supply center will automatically clean the powder suction pipe, powder pump ,powder carried pipes and spray gun When cleaning the powder coating booth.

5. New automatic powder adding device can be configured additionally.

6. Can be equipped additionally with automatic cleaning device for spray gun and a complete body of gun.  

 7.Using High-quality nano-coated filter,it can capture the powder above 0.1 micron.The gas can be discharged/circulated directly in the room after filtered.

 8. The powder supply center adopts the design of saving powder , to reduce the fluidized coating powder to the minimum.

 9.  The  functionalized man-machine interface is with the touch-screen